99 Item Items
Warning: Last items in stock!
Before you decide to buy a CNC router machine make sure that you are making a good choice of the machine you are about to purchase. From our experience, we know that large machines such as 4' x 4' or 4' x 8' and other large machines must be very stiff. There is no other option than to have supported linear & two ball screws or two racks and pinions on X axis. This is very important because large machines with only one Ball screw in the middle or side of the gentry will end with major problems & the machine racking uncontrollably (gentry tillting on the side) If you buy machine 4' x 4' or 4' x 8' with one ball screw under the frame and you attempt to cut parts machine starts to work in the middle of the working area the machine will work correctly. (you may still be able to work) but the big problem occurs once the spindle goes to the left side or right side of the machine then you will notice that the machine will begin to tilt. That's why you have to make sure that you buy a machine created for work and not a toy for several thousand. We are not trying to say our machines are the best, but from our experience we know that there are problems like this. That is why our machines are designed with four ball screws on the X-axis to prevent these problems. CCK 4' x 4' x 8" machines are designed to work with every material. Each of our machines come with supported motions drive SBR 20 mm for each axis, ball screws 16 mm, each axis with the Nema 23 420 oz. (3 Nm) and digital stepper drivers. Certainly, we may change the stepper motors from 23 to the Nema 34 if that is what you'd like. This kit contains all of the aluminum plates, aluminum extrusion, bearings, nuts, Ball screws and SBR 20 supported linear, electronics & spindle.
CNC router kit with a working area of 48 '' x 48 '' x 8 '' (W L H). The base frame is made of 2,36" x 2,36" aluminium extrusion, X axis side arm made of 3/4 aluminium plate & 2.36'' x 3.54''aluminium extrusion, Z-axis arm is made of 1/2 aluminum plates. reinforced with two 3/8 steel plates
4 x High-precision C7 ball screw Q16mm pitch 5mm (C7)
6 x 20mm Precision Linear Rail with 12 bearing blocks for Y X and Z
1.5KW Water-cooled Spindle motor + VFD
Diameter:80mm x Length:205mm
Power: 1.5 KW Voltage: 220V
CNC Driver Controller;
4 x Digital Stepper driver 556D 24V to 50V
1 x Power supply: 600W 48V 12A1
1 x C10 - BI-DIRECTIONAL PARALLEL PORT BREAKOUT BOARD
4 x Stepper Motor 425 oz In.
1.8° /200 Steps Per Rev.
3 Amps Current Per Phase
Z-axis 20 ''
Y-axis 58 ''
x-axis 59 ''
Work area dimensions
Z-axis travel 8 "
Y-axis travel 48 "
X-axis travel 48 "
Paypal payment contact us Send a message
USA Phone (248) 778-5715